Kanjilal, A.; Duarte, M. J.; Scheu, C.; Dehm, G.: Hydrogen Permeation Barrier Layers for the Hydrogen Economy. Annual Review of Materials Research 55, pp. 125 - 149 (2025)
Rao, J.; Lee, S.; Dehm, G.; Duarte, M. J.: Hardening effect of diffusible hydrogen on BCC Fe-based model alloys by in situ backside hydrogen charging. Materials and Design 232, 112143 (2023)
Chakraborty, J.; Harzer, T. P.; Duarte, M. J.; Dehm, G.: Phase decomposition in nanocrystalline Cr0.8Cu0.2 thin films. Journal of Alloys and Compounds 888, 161391 (2021)
Duarte, M. J.; Fang, X.; Rao, J.; Krieger, W.; Brinckmann, S.; Dehm, G.: In situ nanoindentation during electrochemical hydrogen charging: a comparison between front-side and a novel back-side charging approach. Journal of Materials Science 56 (14), pp. 8732 - 8744 (2021)
Manzoni, A. M.; Haas, S.; Kropf, H.; Duarte, M. J.; Cakir, C. T.; Dubois, F.; Többens, D. M.; Glatzel, U.: Temperature evolution of lattice misfit in Hf and Mo variations of the Al10Co25Cr8Fe15Ni36Ti6 compositionally complex alloy. Scripta Materialia 188, pp. 74 - 79 (2020)
International researcher team presents a novel microstructure design strategy for lean medium-manganese steels with optimized properties in the journal Science
Project A02 of the SFB1394 studies dislocations in crystallographic complex phases and investigates the effect of segregation on the structure and properties of defects in the Mg-Al-Ca System.
Within this project, we will investigate the micromechanical properties of STO materials with low and higher content of dislocations at a wide range of strain rates (0.001/s-1000/s). Oxide ceramics have increasing importance as superconductors and their dislocation-based electrical functionalities that will affect these electrical properties. Hence…
In this project, we aim to enhance the mechanical properties of an equiatomic CoCrNi medium-entropy alloy (MEA) by interstitial alloying. Carbon and nitrogen with varying contents have been added into the face-centred cubic structured CoCrNi MEA.
Hydrogen is a clean energy source as its combustion yields only water and heat. However, as hydrogen prefers to accumulate in the concentrated stress region of metallic materials, a few ppm Hydrogen can already cause the unexpected sudden brittle failure, the so-called “hydrogen embrittlement”. The difficulties in directly tracking hydrogen limits…