Klusemann, B.; Fischer, G.; Böhlke, T.; Svendsen, B.: Thermomechanical characterization of Portevin-Le Chatelier bands in AlMg3 (AA5754) and modeling based on a modified Estrin-McCormick approach. International Journal of Plasticity 67, pp. 192 - 216 (2015)
Klusemann, B.; Yalçinkaya, T.; Geers, M. G. D.; Svendsen, B.: Application of non-convex rate dependent gradient plasticity to the modeling and simulation of inelastic microstructure development and inhomogeneous material behavior. Computational Materials Science 80, pp. 51 - 60 (2013)
Klusemann, B.; Svendsen, B.; Vehoff, H.: Modeling and simulation of deformation behavior, orientation gradient development and heterogeneous hardening in thin sheets with coarse texture. International Journal of Plasticity 50, pp. 109 - 126 (2013)
Klusemann, B.; Svendsen, B.; Bargmann, S.: Analysis and comparison of two finite element algorithms for dislocation density based crystal plasticity. GAMM-Mitteilungen 36 (2), pp. 219 - 238 (2013)
Barthel, C.; Klusemann, B.; Denzer, R.; Svendsen, B.: Modeling of a thermomechanical process chain for sheet steels. International Journal of Mechanical Sciences 74, pp. 46 - 54 (2013)
International researcher team presents a novel microstructure design strategy for lean medium-manganese steels with optimized properties in the journal Science
Project A02 of the SFB1394 studies dislocations in crystallographic complex phases and investigates the effect of segregation on the structure and properties of defects in the Mg-Al-Ca System.
Within this project, we will investigate the micromechanical properties of STO materials with low and higher content of dislocations at a wide range of strain rates (0.001/s-1000/s). Oxide ceramics have increasing importance as superconductors and their dislocation-based electrical functionalities that will affect these electrical properties. Hence…
In this project, we aim to enhance the mechanical properties of an equiatomic CoCrNi medium-entropy alloy (MEA) by interstitial alloying. Carbon and nitrogen with varying contents have been added into the face-centred cubic structured CoCrNi MEA.
Hydrogen is a clean energy source as its combustion yields only water and heat. However, as hydrogen prefers to accumulate in the concentrated stress region of metallic materials, a few ppm Hydrogen can already cause the unexpected sudden brittle failure, the so-called “hydrogen embrittlement”. The difficulties in directly tracking hydrogen limits…