Changizi, R.; Zaefferer, S.; Abdellaoui, L.; Scheu, C.: Effects of Defect Density on Optical Properties Using Correlative Cathodoluminescence and Transmission Electron Microscopy Measurements on Identical PrNbO4 Particles. ACS Applied Electronic Materials 4 (4), pp. 2095 - 2100 (2022)
Tsai, S.-P.; Konijnenberg, P. J.; Gonzalez, I.; Hartke, S.; Griffiths, T. A.; Herbig, M.; Kawano-Miyata, K.; Taniyama, A.; Sano, N.; Zaefferer, S.: Development of a new, fully automated system for electron backscatter diffraction (EBSD)-based large volume three-dimensional microstructure mapping using serial sectioning by mechanical polishing, and its application to the analysis of special boundaries in 316L stainless steel. Review of Scientific Instruments 93, 093707 (2022)
Nandy, S.; Tsai, S.-P.; Stephenson, L.; Raabe, D.; Zaefferer, S.: The role of Ca, Al and Zn on room temperature ductility and grain boundary cohesion of magnesium. Journal of Magnesium and Alloys 9 (5), pp. 1521 - 1536 (2021)
Varanasi, R. S.; Zaefferer, S.; Sun, B.; Ponge, D.: Localized deformation inside the Lüders front of a medium manganese steel. Materials Science and Engineering A: Structural Materials Properties Microstructure and Processing 824, 141816 (2021)
Zhang, J.; Zaefferer, S.: Influence of sample preparation on nanoindentation results of twinning-induced plasticity steel. International Journal of Minerals, Metallurgy and Materials 28, pp. 877 - 887 (2021)
Guo, X.; Zaefferer, S.; Archie, F. M. F.; Bleck, W.: Hydrogen effect on the mechanical behaviour and microstructural features of a Fe–Mn–C twinning induced plasticity steel. International Journal of Minerals, Metallurgy and Materials 28, pp. 835 - 846 (2021)
An, D.; Zhang, X.; Zaefferer, S.: The combined and interactive effects of orientation, strain amplitude, cycle number, stacking fault energy and hydrogen doping on microstructure evolution of polycrystalline high-manganese steels under low-cycle fatigue. International Journal of Plasticity 134, 102803 (2020)
An, D.; Zhao, H.; Sun, B.; Zaefferer, S.: Direct observations of collinear dislocation interaction in a Fe–17.4 Mn–1.50 Al–0.29 C (wt.%) austenitic steel under cyclic loading by in-situ electron channelling contrast imaging and cross-correlation electron backscatter diffraction. Scripta Materialia 186, pp. 341 - 345 (2020)
Hydrogen in aluminium can cause embrittlement and critical failure. However, the behaviour of hydrogen in aluminium was not yet understood. Scientists at the Max-Planck-Institut für Eisenforschung were able to locate hydrogen inside aluminium’s microstructure and designed strategies to trap the hydrogen atoms inside the microstructure. This can…
Microbiologically influenced corrosion (MIC) of iron by marine sulfate reducing bacteria (SRB) is studied electrochemically and surfaces of corroded samples have been investigated in a long-term project.
Hydrogen embrittlement (HE) of steel is a great challenge in engineering applications. However, the HE mechanisms are not fully understood. Conventional studies of HE are mostly based on post mortem observations of the microstructure evolution and those results can be misleading due to intermediate H diffusion. Therefore, experiments with a…
Smaller is stronger” is well known in micromechanics, but the properties far from the quasi-static regime and the nominal temperatures remain unexplored. This research will bridge this gap on how materials behave under the extreme conditions of strain rate and temperature, to enhance fundamental understanding of their deformation mechanisms. The…
Oxidation and corrosion of noble metals is a fundamental problem of crucial importance in the advancement of the long-term renewable energy concept strategy. In our group we use state-of-the-art electrochemical scanning flow cell (SFC) coupled with inductively coupled plasma mass spectrometer (ICP-MS) setup to address the problem.
In this project we investigate the hydrogen distribution and desorption behavior in an electrochemically hydrogen-charged binary Ni-Nb model alloy. The aim is to study the role of the delta phase in hydrogen embrittlement of the Ni-base alloy 718.
We plan to investigate the rate-dependent tensile properties of 2D materials such as HCP metal thin films and PbMoO4 (PMO) films by using a combination of a novel plan-view FIB based sample lift out method and a MEMS based in situ tensile testing platform inside a TEM.
Hydrogen induced embrittlement of metals is one of the long standing unresolved problems in Materials Science. A hierarchical multiscale approach is used to investigate the underlying atomistic mechanisms.
For understanding the underlying hydrogen embrittlement mechanism in transformation-induced plasticity steels, the process of damage evolution in a model austenite/martensite dual-phase microstructure following hydrogenation was investigated through multi-scale electron channelling contrast imaging and in situ optical microscopy.