Dehm, G.; Inkson, B. J.; Wagner, T. A.: Growth and microstructural stability of epitaxial Al films on (0001) α-Al2O3 substrates. Acta Materialia 50 (20), pp. 5021 - 5032 (2002)
Inkson, B. J.; Dehm, G.; Wagner, T. A.: In-situ TEM observation of dislocation motion in thermally strained Al nanowires. Acta Materialia 50 (20), pp. 5033 - 5047 (2002)
Beschliesser, M.; Chatterjee, A.; Lorich, A.; Knabl, W.; Kestler, H.; Dehm, G.; Clemens, H.: Designed fully lamellar microstructures in a γ-TiAl based alloy: adjustment and microstructural changes upon long-term isothermal exposure at 700 and 800 degrees C. Materials Science and Engineering A-Structural Materials Properties Microstructure and Processing 329-331, pp. 124 - 129 (2002)
Dehm, G.; Balk, T. J.; von Blanckenhagen, B.; Gumbsch, P.; Arzt, E.: Dislocation dynamics in sub-micron confinement: recent progress in Cu thin film plasticity. Zeitschrift für Metallkunde/Materials Research and Advanced Techniques 93 (5), pp. 383 - 391 (2002)
Schillinger, W.; Clemens, H.; Dehm, G.; Bartels, A.: Microstructural stability and creep behavior of a lamellar γ-TiAl based alloy with extremely fine lamellar spacing. Intermetallics 10 (5), pp. 459 - 466 (2002)
Bartels, A.; Clemens, H.; Dehm, G.; Lach, E.; Schillinger, W.: Strain rate dependence of the deformation mechanisms in a fully lamellar γ-TiAl-based alloy. Zeitschrift für Metallkunde/Materials Research and Advanced Techniques 93 (3), pp. 180 - 185 (2002)
Dehm, G.; Wagner, T. A.; Balk, T. J.; Arzt, E.; Inkson, B. J.: Plasticity and interfacial dislocation mechanisms in epitaxial and polycrystalline Al films constrained by substrates. Journal of Materials Science & Technology 18 (2), pp. 113 - 117 (2002)
Kobrinsky, M. J.; Dehm, G.; Thompson, C. L.; Arzt, E.: Effects of thickness on the characteristic length scale of dislocation plasticity in Ag thin films. Acta Materialia 49 (17), pp. 3597 - 3607 (2001)
Dehm, G.; Weiss, D.; Arzt, E.: In situ transmission electron microscopy study of thermal-stress-induced dislocations in a thin Cu film constrained by a Si substrate. Materials Science and Engineering A: Structural Materials Properties Microstructure and Processing 309-310, pp. 468 - 472 (2001)
Legros, M.; Dehm, G.; Keller-Flaig, R.-M.; Arzt, E.; Hemker, K. J.; Süresh, S.: Dynamic observation of Al thin films plastically strained in a TEM. Materials Science and Engineering A: Structural Materials Properties Microstructure and Processing 309-310, pp. 463 - 467 (2001)
Scheu, C.; Dehm, G.; Kaplan, W. D.: Equilibrium amorphous silicon-calcium-oxygen films at interfaces in copper-alumina composites prepared by melt infiltration. Journal of the American Ceramic Society 84 (3), pp. 623 - 630 (2001)
Zhang, D.; Dehm, G.; Clemens, H.: On the microstructural evolution and phase transformation in a high niobium containing γ-TiAl alloy. Zeitschrift für Metallkunde 91 (11), pp. 950 - 956 (2000)
Chatterjee, A.; Dehm, G.; Scheu, C.; Clemens, H.: Onset of microstructural instability in a fully lamellar Ti-46.5 at.% Al-4 al.% (Cr,Nb,Ta,B) alloy during short-term creep. Zeitschrift für Metallkunde/Materials Research and Advanced Techniques 91 (9), pp. 755 - 760 (2000)
Dehm, G.; Arzt, E.: In-situ transmission electron microscopy study of dislocations in a polycrystalline Cu thin film constrained by a substrate. Applied Physics Letters 77 (8), pp. 1126 - 1128 (2000)
Hydrogen in aluminium can cause embrittlement and critical failure. However, the behaviour of hydrogen in aluminium was not yet understood. Scientists at the Max-Planck-Institut für Eisenforschung were able to locate hydrogen inside aluminium’s microstructure and designed strategies to trap the hydrogen atoms inside the microstructure. This can…
Microbiologically influenced corrosion (MIC) of iron by marine sulfate reducing bacteria (SRB) is studied electrochemically and surfaces of corroded samples have been investigated in a long-term project.
In this project we investigate the hydrogen distribution and desorption behavior in an electrochemically hydrogen-charged binary Ni-Nb model alloy. The aim is to study the role of the delta phase in hydrogen embrittlement of the Ni-base alloy 718.
Smaller is stronger” is well known in micromechanics, but the properties far from the quasi-static regime and the nominal temperatures remain unexplored. This research will bridge this gap on how materials behave under the extreme conditions of strain rate and temperature, to enhance fundamental understanding of their deformation mechanisms. The…
Biological materials in nature have a lot to teach us when in comes to creating tough bio-inspired designs. This project aims to explore the unknown impact mitigation mechanisms of the muskox head (ovibus moschatus) at several length scales and use this gained knowledge to develop a novel mesoscale (10 µm to 1000 µm) metamaterial that can mimic the…
Oxidation and corrosion of noble metals is a fundamental problem of crucial importance in the advancement of the long-term renewable energy concept strategy. In our group we use state-of-the-art electrochemical scanning flow cell (SFC) coupled with inductively coupled plasma mass spectrometer (ICP-MS) setup to address the problem.
For understanding the underlying hydrogen embrittlement mechanism in transformation-induced plasticity steels, the process of damage evolution in a model austenite/martensite dual-phase microstructure following hydrogenation was investigated through multi-scale electron channelling contrast imaging and in situ optical microscopy.
We plan to investigate the rate-dependent tensile properties of 2D materials such as metal thin films and PbMoO4 (PMO) films by using a combination of a novel plan-view FIB based sample lift out method and a MEMS based in situ tensile testing platform inside a TEM.
This project aims to investigate the influence of grain boundaries on mechanical behavior at ultra-high strain rates and low temperatures. For this micropillar compressions on copper bi-crystals containing different grain boundaries will be performed.