Bartels, A.; Clemens, H.; Dehm, G.; Lach, E.; Schillinger, W.: Strain rate dependence of the deformation mechanisms in a fully lamellar γ-TiAl-based alloy. Zeitschrift für Metallkunde/Materials Research and Advanced Techniques 93 (3), pp. 180 - 185 (2002)
Dehm, G.; Wagner, T. A.; Balk, T. J.; Arzt, E.; Inkson, B. J.: Plasticity and interfacial dislocation mechanisms in epitaxial and polycrystalline Al films constrained by substrates. Journal of Materials Science & Technology 18 (2), pp. 113 - 117 (2002)
Kobrinsky, M. J.; Dehm, G.; Thompson, C. L.; Arzt, E.: Effects of thickness on the characteristic length scale of dislocation plasticity in Ag thin films. Acta Materialia 49 (17), pp. 3597 - 3607 (2001)
Dehm, G.; Weiss, D.; Arzt, E.: In situ transmission electron microscopy study of thermal-stress-induced dislocations in a thin Cu film constrained by a Si substrate. Materials Science and Engineering A: Structural Materials Properties Microstructure and Processing 309-310, pp. 468 - 472 (2001)
Legros, M.; Dehm, G.; Keller-Flaig, R.-M.; Arzt, E.; Hemker, K. J.; Süresh, S.: Dynamic observation of Al thin films plastically strained in a TEM. Materials Science and Engineering A: Structural Materials Properties Microstructure and Processing 309-310, pp. 463 - 467 (2001)
Scheu, C.; Dehm, G.; Kaplan, W. D.: Equilibrium amorphous silicon-calcium-oxygen films at interfaces in copper-alumina composites prepared by melt infiltration. Journal of the American Ceramic Society 84 (3), pp. 623 - 630 (2001)
Zhang, D.; Dehm, G.; Clemens, H.: On the microstructural evolution and phase transformation in a high niobium containing γ-TiAl alloy. Zeitschrift für Metallkunde 91 (11), pp. 950 - 956 (2000)
Chatterjee, A.; Dehm, G.; Scheu, C.; Clemens, H.: Onset of microstructural instability in a fully lamellar Ti-46.5 at.% Al-4 al.% (Cr,Nb,Ta,B) alloy during short-term creep. Zeitschrift für Metallkunde/Materials Research and Advanced Techniques 91 (9), pp. 755 - 760 (2000)
Dehm, G.; Arzt, E.: In-situ transmission electron microscopy study of dislocations in a polycrystalline Cu thin film constrained by a substrate. Applied Physics Letters 77 (8), pp. 1126 - 1128 (2000)
Zhang, D.; Dehm, G.; Clemens, H.: Effect of heat treatments and hot-isostatic pressing on phase transformations and microstructure in a β/B2 containing γ-TiAl based alloy. Scripta Materialia 42 (11), pp. 1065 - 1070 (2000)
Dehm, G.; Scheu, C.; Bamberger, M. S.: Microstructure of Iron Substrates Borided with Ni2B Particles by Laser-Induced Surface-Alloying. Zeitschrift für Metallkunde 90 (11), pp. 920 - 929 (1999)
Bidlingmaier, T.; Wanner, A.; Dehm, G.; Clemens, H.: Acoustic Emission during Room Temperature Deformation of a γ-TiAl Based Alloy. Zeitschrift für Metallkunde 90, pp. 581 - 587 (1999)
Hydrogen in aluminium can cause embrittlement and critical failure. However, the behaviour of hydrogen in aluminium was not yet understood. Scientists at the Max-Planck-Institut für Eisenforschung were able to locate hydrogen inside aluminium’s microstructure and designed strategies to trap the hydrogen atoms inside the microstructure. This can…
With the support of DFG, in this project the interaction of H with mechanical, chemical and electrochemical properties in ferritic Fe-based alloys is investigated by the means of in-situ nanoindentation, which can characterize the mechanical behavior of independent features within a material upon the simultaneous charge of H.
The goal of this project is the investigation of interplay between the atomic-scale chemistry and the strain rate in affecting the deformation response of Zr-based BMGs. Of special interest are the shear transformation zone nucleation in the elastic regime and the shear band propagation in the plastic regime of BMGs.
“Smaller is stronger” is well known in micromechanics, but the properties far from the quasi-static regime and the nominal temperatures remain unexplored. This research will bridge this gap on how materials behave under the extreme conditions of strain rate and temperature, to enhance fundamental understanding of their deformation mechanisms. The…
Hydrogen embrittlement (HE) of steel is a great challenge in engineering applications. However, the HE mechanisms are not fully understood. Conventional studies of HE are mostly based on post mortem observations of the microstructure evolution and those results can be misleading due to intermediate H diffusion. Therefore, experiments with a…
Smaller is stronger” is well known in micromechanics, but the properties far from the quasi-static regime and the nominal temperatures remain unexplored. This research will bridge this gap on how materials behave under the extreme conditions of strain rate and temperature, to enhance fundamental understanding of their deformation mechanisms. The…
Biological materials in nature have a lot to teach us when in comes to creating tough bio-inspired designs. This project aims to explore the unknown impact mitigation mechanisms of the muskox head (ovibus moschatus) at several length scales and use this gained knowledge to develop a novel mesoscale (10 µm to 1000 µm) metamaterial that can mimic the…