© Max-Planck-Institut für Eisenforschung GmbH

Publications
This list consists only of publications since the formation of the department "Structure and Nano-/Micromechanics of Materials". If you click on an author's name, you will be directed to the authors complete MPS publication list.

Journal Article (60)

1.
Journal Article
Xia, W.; Patil, P.; Liu, C.; Dehm, G.; Brinckmann, S.: A novel microwall sliding test uncovering the origin of grain refined tribolayers. Acta Materialia 246, 118670 (2023)
MPG.PuRe
DOI
2.
Journal Article
Patil, P.; Lee, S.; Dehm, G.; Brinckmann, S.: Influence of crystal orientation on twinning in austenitic stainless-steel during single micro-asperity tribology and nanoindentation. WEAR 504-505, 204403 (2022)
MPG.PuRe
DOI
publisher-version
3.
Journal Article
Bishara, H.; Tsybenko, H.; Nandy, S.; Muhammad, Q. K.; Frömling, T.; Fang, X.; Best, J. P.; Dehm, G.: Dislocation-enhanced electrical conductivity in rutile TiO2 accessed by room-temperature nanoindentation. Scripta Materialia 212, 114543 (2022)
MPG.PuRe
DOI
publisher-version
4.
Journal Article
Liu, C.; Lu, W.; Xia, W.; Du, C.; Rao, Z.; Best, J. P.; Brinckmann, S.; Lu, J.; Gault, B.; Dehm, G. et al.; Wu, G.; Li, Z.; Raabe, D.: Massive interstitial solid solution alloys achieve near-theoretical strength. Nature Communications 13, 1102 (2022)
MPG.PuRe
DOI
publisher-version
5.
Journal Article
Chakraborty, J.; Harzer, T. P.; Duarte, M. J.; Dehm, G.: Phase decomposition in nanocrystalline Cr0.8Cu0.2 thin films. Journal of Alloys and Compounds 888, 161391 (2021)
MPG.PuRe
DOI
publisher-version
6.
Journal Article
Wu, G.; Liu, C.; Brognara, A.; Ghidelli, M.; Bao, Y.; Liu, S.; Wu, X.; Xia, W.; Zhao, H.; Rao, J. et al.; Ponge, D.; Devulapalli, V.; Lu, W.; Dehm, G.; Raabe, D.; Li, Z.: Symbiotic crystal-glass alloys via dynamic chemical partitioning. Materials Today 51, pp. 6 - 14 (2021)
MPG.PuRe
DOI
7.
Journal Article
Tsybenko, H.; Farzam, F.; Dehm, G.; Brinckmann, S.: Scratch hardness at a small scale: Experimental methods and correlation to nanoindentation hardness. Tribology International 163, 107168 (2021)
MPG.PuRe
DOI
8.
Journal Article
Liu, C.; Li, Z.; Lu, W.; Bao, Y.; Xia, W.; Wu, X.; Zhao, H.; Gault, B.; Liu, C.; Herbig, M. et al.; Fischer, A.; Dehm, G.; Wu, G.; Raabe, D.: Reactive wear protection through strong and deformable oxide nanocomposite surfaces. Nature Communications 12 (1), 5518 (2021)
MPG.PuRe
DOI
publisher-version
9.
Journal Article
Fang, X.; Bishara, H.; Ding, K.; Tsybenko, H.; Porz, L.; Höfling, M.; Bruder, E.; Li, Y.; Dehm, G.; Durst, K.: Nanoindentation pop‐in in oxides at room temperature: dislocation activation or crack formation? Journal of the American Ceramic Society 104 (9), pp. 4728 - 4741 (2021)
MPG.PuRe
DOI
publisher-version
10.
Journal Article
Duarte, M. J.; Fang, X.; Rao, J.; Krieger, W.; Brinckmann, S.; Dehm, G.: In situ nanoindentation during electrochemical hydrogen charging: a comparison between front-side and a novel back-side charging approach. Journal of Materials Science 56 (14), pp. 8732 - 8744 (2021)
MPG.PuRe
DOI
publisher-version
11.
Journal Article
Manzoni, A. M.; Haas, S.; Kropf, H.; Duarte, M. J.; Cakir, C. T.; Dubois, F.; Többens, D. M.; Glatzel, U.: Temperature evolution of lattice misfit in Hf and Mo variations of the Al10Co25Cr8Fe15Ni36Ti6 compositionally complex alloy. Scripta Materialia 188, pp. 74 - 79 (2020)
MPG.PuRe
DOI
12.
Journal Article
Tsybenko, H.; Xia, W.; Dehm, G.; Brinckmann, S.: On the commensuration of plastic plowing at the microscale. Tribology International 151, 106477 (2020)
MPG.PuRe
DOI
13.
Journal Article
Xia, W.; Dehm, G.; Brinckmann, S.: Investigation of single asperity wear at the microscale in an austenitic steel. WEAR 452–453, 203289 (2020)
MPG.PuRe
DOI
publisher-version
14.
Journal Article
Saxena, A. K.; Brinckmann, S.; Völker, B.; Dehm, G.; Kirchlechner, C.: Experimental conditions affecting the measured fracture toughness at the microscale: Notch geometry and crack extension measurement. Materials and Design 191, 108582 (2020)
MPG.PuRe
DOI
publisher-version
15.
Journal Article
Meiners, T.; Duarte, M. J.; Richter, G.; Dehm, G.; Liebscher, C.: Tantalum and Zirconium induced structural transitions at complex [111] tilt grain boundaries in Copper. Acta Materialia 190, pp. 93 - 104 (2020)
MPG.PuRe
DOI
publisher-version
16.
Journal Article
Xia, W.; Dehm, G.; Brinckmann, S.: Insight into indentation-induced plastic flow in austenitic stainless steel. Journal of Materials Science 55, pp. 9095 - 9108 (2020)
MPG.PuRe
DOI
publisher-version
17.
Journal Article
Ebner, A. S.; Brinckmann, S.; Plesiutschnig, E.; Clemens, H.; Pippan, R.; Maier-Kiener, V.: A Modified Electrochemical Nanoindentation Setup for Probing Hydrogen-Material Interaction Demonstrated on a Nickel-Based Alloy. JOM-Journal of the Minerals Metals & Materials Society 72 (5), pp. 2020 - 2029 (2020)
MPG.PuRe
DOI
publisher-version
18.
Journal Article
Wang, Z.; Guo, L.; Xia, W.; Yuan, Z.; Cao, Y.; Ni, S.; Song, M.: An SEM-based approach to characterize the microstructural evolution in a gradient CoCrFeNiMo0.15 high-entropy alloy. Materials Characterization 161, 110169 (2020)
MPG.PuRe
DOI
19.
Journal Article
Lu, W.; Liebscher, C.; Yan, F.; Fang, X.; Li, L.; Li, J.; Guo, W.; Dehm, G.; Raabe, D.; Li, Z.: Interfacial nanophases stabilize nanotwins in high-entropy alloys. Acta Materialia 185, pp. 218 - 232 (2020)
MPG.PuRe
DOI
20.
Journal Article
Katnagallu, S.; Wu, G.; Singh, S. P.; Nandam, S. H.; Xia, W.; Stephenson, L.; Gleiter, H.; Schwaiger, R.; Hahn, H.; Herbig, M. et al.; Raabe, D.; Gault, B.; Balachandran, S.: Nanoglass–Nanocrystal Composite - a Novel Material Class for Enhanced Strength-Plasticity Synergy. Small 16 (39), 2004400 (2020)
MPG.PuRe
DOI
publisher-version
Web-View
Print Page
Open in new window
Estimated DIN-A4 page-width
Go to Editor View