Copyright Max-Planck-Institut für Eisenfoschung GmbH

Publications of Eric Aimé Jägle

Poster (9)

101.
Poster
Springer, H.; Uhlenwinkel, V.; Baron, C.; Szczepaniak, A.; Jägle, E. A.; Raabe, D.: Innovative Metallurgical Design Strategies Tailored to Additive Manufacturing. MRS spring meeting, Phoenix, AZ, USA (2018)
102.
Poster
Bajaj, P.; Gupta, A.; Jägle, E. A.; Raabe, D.: Precipitation kinetics during non-linear heat treatment in Laser Additive Manufacturing. International Conference on Advanced Materials and Processes, ‘ADMAT 2017’ SkyMat, Thiruvananthapuram, India (2017)
103.
Poster
Bajaj, P.; Kürnsteiner, P.; Wilms, M. B.; Weisheit, A.; Jägle, E. A.; Raabe, D.: Precipitation kinetics during non-linear heat treatment in Laser Additive Manufacturing (LAM). Alloys for Additive Manufacturing Symposium, Zürich, Switzerland (2017)
104.
Poster
Kürnsteiner, P.; Wilms, M. B.; Weisheit, A.; Barriobero-Vila, P.; Jägle, E. A.; Raabe, D.: Designing a novel Fe–Ni–Al Maraging steel for Laser Metal Deposition exploiting Intrinsic Heat Treatment. EUROMAT 2017 Conference, Thessaloniki, Greece (2017)
105.
Poster
Kürnsteiner, P.; Wilms, M. B.; Weisheit, A.; Barriobero-Vila, P.; Jägle, E. A.; Raabe, D.: Designing a novel Fe–Ni–Al Maraging steel optimised for Laser Metal Deposition. Alloys for Additive Manufacturing Symposium, Zürich, Switzerland (2017)

Teaching (1)

106.
Teaching
Jägle, E. A.: Microstructural Aspects of Additive Manufacturing. Lecture: Workshop “Microstructural Aspects of Additive Manufacturing”, Indian Institute of Technology Roorkee, 3,5h of lectures, Roorkee, India, December 02, 2017

Thesis - Master (3)

107.
Thesis - Master
Qin, S.: Measurement of solidification characteristics of steel during Selective Laser Melting using high-speed pyrometry. Master, RWTH Aachen, Aachen, Germany (2018)
108.
Thesis - Master
Ackers, M.: Recommissioning of a metal powder atomisation system and investigation of its suitability to produce powders for additive Manufacturing processes. Master, Ruhr-Universität Bochum, Bochum, Germany (2017)
109.
Thesis - Master
Qin, Y.: Effect of post-heat treatment on the microstructure and mechanical properties of SLM-produced IN738LC. Master, RWTH Aachen, Aachen, Germany (2017)

Opinion (1)

110.
Opinion
Jägle, E. A.; Raabe, D.; et al: Additive Fertigung – Entwicklungen, Möglichkeiten und Herausforderungen. (2020), 120 pp.
Go to Editor View