Suchergebnisse

Zaiser, E.; Meng, W.; Zhou, X.; Mantha, L.; Pavel, M.; Neumeier, S.; Long, Y.; Weaver, M.; Gault, B.; Wu, Y. et al.; Vogel, F.: Cr-induced phase instability and hierarchical microstructure development in Co-based superalloys. Journal of Materials Science & Technology 261, S. 309 - 321 (2026)

Riedel, J.; Kauffmann, A.; Guth, S.; Muench, M.; Winkens, G.; Schliephake, D.; Lee, J. S.; Best, J. P.; Stein, F.; Heilmaier, M.: Re-assessment of temperature-dependent strength, strain hardening, and deformation behavior in binary Fe–Al intermetallics. Intermetallics 193, 109273 (2026)

Vacirca, D.; Bignoli, F.; Li Bassi, A.; Dai, Y.; Ahmadian, A.; Abadias, G.; Djemia, P.; Dehm, G.; Best, J. P.; Ghidelli, M.: Ultrafine CoCrCuFeNi high entropy alloy thin films with high strength, plastic deformability and thermal stability achieved via grain engineering and nanoclustering. Materials Today 95, 103280 (2026)

Woods, E.; Chen, X.; Zhang, Y.; Prabhakar, J. M.; Jovičević-Klug, P.; Jovičević-Klug, M.; Singh, M. P.; Zhao, Y.; Zhang, S.; Zaefferer, S. et al.; Liu, J.; Joshi, Y.; Gault, B.: Electrochemically-driven formation of Intermetallic Cu₃ZnLi₂ alters Li-transport in nanostructured bimetallic battery anode. Journal of Power Sources 676, 239832 (2026)

Silva, C. C.; Silva, R. S.; Miná, É. M.; Motta, M. F.; Miranda, H. C.; Dalpiaz, G.; Marinho, R. R.; Paes, M. T. P.; Kwiatkowski da Silva, A.; Wossack, I. et al.; Liebscher, C.: Heterogeneously structured Ni-based alloy obtained by wire-arc additive manufacturing overcomes the strength-ductility trade-off. Journal of Materials Science & Technology 254, S. 168 - 179 (2026)

Bu, Y.; Li, K.; Ma, Y.; Liang, Z.; Jianliang, Z.; Raabe, D.: Atomistic view of green steel: simulation of early-stage direct reduction of wüstite (FeO) by hydrogen. Chemical Engineering Science 326, 123611 (2026)

Lee, J. S.; Riedel, J. L.; Schweizer, P.; Kauffmann, A.; Heilmaier, M.; Dehm, G.; Best, J. P.; Kanjilal, A.; Stein, F.: Influence of point defects on the hardness and reduced modulus of B2-ordered FeAl. Journal of Alloys and Compounds 1065, 188036 (2026)

Bhat, M. K.; Jung, C.; Evertz, S.; Best, J. P.; Dehm, G.: Overcoming the strength ductility trade off in nanostructured copper alloys. Materials and Design 265, 115963 (2026)

Hatipoglu, E.; El-Zoka, A.; Zhao, Y.; Mráz, S.; Schneider, J.; Gault, B.; Saksena, A.: Effect of crystallographic texture on dealloying kinetics and composition of nanoporous gold surface. Scripta Materialia 277, 117226 (2026)

Mead, M.; Kerner, N.; Talei, R.; Joshi, Y.; Schmitz, G.: Lithium transport from operando microscopy: Kinetic trapping in lithium manganese oxide. Nano Energy 151, 111797 (2026)

Zhang, X.; Li, Y.; Wei, S.; Guo, H.; He, Z.; Yang, C.; Gong, W.; Harjo, S.; Zhou, D.; Li, Z. et al.; Zhang, D.; Raabe, D.; Qin, G.: Interplay of dynamic strain aging and dynamic precipitation in the Portevin-Le Chatelier effect in an Al–Mg–Zn-based crossover aluminum alloy. Acta Materialia 308, 121990 (2026)

Li, Y.; Kwesi Nutor, R.; Gault, B.: L12-type chemical short-range ordering in compositionally complex alloys. Journal of Materials Science & Technology 250, S. 188 - 196 (2026)

Polin, N.; Shen, S.; Maccari, F.; Aubert, A.; Adabifiroozjaei, E.; Smoliarova, T.; Yang, Y.; Chen, X.; Skourski, Y.; Saxena, A. et al.; Kovács, A.; Dunin-Borkowski, R.; Farle, M.; Xu, B.-X.; Molina-Luna, L.; Gutfleisch, O.; Gault, B.; Skokov, K.: Direct observation of nanoscale pinning centers in Ce(Co0.8Cu0.2)5.4 permanent magnets. Acta Materialia 307, 121906 (2026)

Song, S.; Jin Jang, T.; Sun Lee, C.; Yang, D.-C.; Sung, M.; Lee, G.; Han, J.; Baek, J.-H.; Suh, J.-Y.; Zargaran, A. et al.; Saksena, A.; Gault, B.; Ko, W.-S.; Kim, S.-H.; Su Sohn, S.: Reconciling ultrahigh strength and hydrogen embrittlement resistance via discontinuous L12 precipitation in a high-entropy alloy. Acta Materialia 307, 121972 (2026)

Jiang, Y.; Aymerich Armengol, R.; Efthimiopoulos, I.; Rabe, M.; Mingers, A. M.; Cheng, N.; Breitbach, B.; Santra, S.; Streibel, V.; Sharp, I. D. et al.; Vogl, L. M.; Scheu, C.; Zhang, S.: Degradation Mechanisms of Rutile-Type TiO₂ Photoanodes during Photoelectrochemical Water Splitting. Advanced Energy Materials (e06779) (2026)

Zavanelli, D.; Isotta, E.; Busch, F.; Zhang, S.; Scheu, C.; Bux, S.; Snyder, G. J.: High temperature grain boundary resistance in Yb₁₄ (Mg,Mn)Sb₁₁ thermoelectrics. Journal of Materials Chemistry A (16) (2026)

Parsa, A. B.; Saksena, A.; Kostka, A.; Thome, P.; Scholz, F.; Mussi, A.; Somsen, C.; Gault, B.; Frenzel, J.; Eggeler, G.: Low-Angle Grain Boundaries and Re-Segregation in Single-Crystalline Ni-Base Superalloys. Advanced Engineering Materials, e202502851 (2026)

Götz, R.; Pyyhtiä, K.; Li, B.; Sarpey, T.; Song, K.; Todorova, M.; Kukharchyk, N.; Schreier, S.; Peljo, P.; Gubanova, E. et al.; Neugebauer, J.; Bandarenka, A.: In Situ EC‐EPR Spectroscopy and DFT Analysis of HUPD on Polycrystalline Pt. ChemSusChem 19 (5), e202501908 (2026)

Lee, C.-G.; Chae, B.-G.; Ro, I.-J.; Jang, K.; Kim, N.-K.; Ahn, J.-P.; Woods, E.; Ahn, J.; Park, S.; Gault, B. et al.; Kim, S.-H.: Performance evaluation of deep-ultraviolet laser-assisted Invizo 6000 and near-ultraviolet laser-assisted LEAP 5000 for a range of material systems. Ultramicroscopy 281, 114296 (2026)

Li, J.; He, S.; Röder, F.; Winkler, J.; Zhao, P.; Jang, K.; Zhang, S.; Pandey, A.; Wrzesińska-Lashkova, A.; Vaynzof, Y. et al.; Scheu, C.; Nielsch, K.; Bahrami, A.: Atomic Layer Deposited Cu Incorporation Enables Enhanced Thermoelectric Performance in n-Type Mg₃(Sb, Bi)₂. Small structures 7 (3), e202500906 (2026)